Home
About Us
Repairs
Specials
Astro-Glow
Scope-Totes
Scope-Gripps
Unitron Drives
Dob Kits
Telescopes
Binoculars
Eyepieces
Mounts
Accessories

ScopeGripp's

ScopeGripp II  ( new version)

For Orion, Hardin, Antares, DBA, Zhummel* : Dobsonian Telescopes)

Our new version of ScopeGripp is machined from ABS plastic and work the same as our Original version at less cost.

1)Fine tuning  balance for heavier eyepieces and binoviewers: We use four vane "Phenolic handles" with stainless bolts on each side, and machined "ABS"  side bearings to  allow the user to fine tune the amount of tension to the altitude bearings.

2) Smoothness of altitude movement:  "ABS"  has a lubricity between Delrin and Nylon, it's just right smoothness, will not scratch the plastic bearing material.

3) Set up and break down time: Scope-Gripp II are slotted so moving the OTA in and out of the cradle is a breeze, just back off the handles a few turns and lift.

                  

            Close-up ScopeGripp II                   Orion Dob with heavy Stratus eyepiece   ScopeGripp I on Zhummel 10" 

 

Installation is easy!

Remove the springs, and screws.  Place the Scopegripp II over the bottom hole and

align slot with top hole. Add original knobs or our upgrade knobs. adjust tension to fit your needs. 

 

Orion, Hardin, Antares, DBA and Zhummel Scope* ( see note below)

  

ScopeGrip II for 8 inch Dob with custom handles 49.99
 

 

ScopeGripp II for 10 inch Dob  with custom handles  49.99 (8 inch Zhummel )
 

 

ScopeGripp II for 12 inch Dob   with Custom handles 49.99 (10 inch Zhummel )
 

 

ScopeGripp II for 12 inch Zhummel with custom Handles   59.99
 

 

  
   

Zhummel Special Notes

Zhummel Dobs are a very  good value for the money, we do not carry them, but, do support these telescopes  with all of our upgrade kits.  Since they are a new company, some of  the hardware and cradle sizes vary, therefore ,if you are ordering Scope-grip II  for a Zhummel scope ,order gripps one size up and please email me to verify (Gripp Knobb Spacing). or Order Scope-gripp I please see photo below.

thank you

Tony C 

This and all of our products are proudly made in the USA.

Warranty: on all machined parts and handles 5 years.

 

Quotes from users:

The ScopeGrip's work great! I'm using them on a 10" Hardin, and have a finder scope, tetrad, 2" Barlow and a 2" 15mm eyepiece attached. The ScopeGrip's keep the scope right where I put it! No drift or sag. In fact, I was able to loosen them to make the movement a little smoother and they still held tight! After observing, just a couple of turns and the scope comes right out of the rocker box. A great product!! Wish I had thought of it!

Jim

redmer@wideopenwest.co